- Product Details
Although unbeatable on price, the SlipGrip Standard Flat Sheets still maintains the excellent quality of the SlipGrip range. Best used to make slippery walkways and ramps safe, our Standard Flat Sheets are a general purpose, tough GRP suitable for both industrial and commerical use.
Difference between Standard & Heavy Duty Products
Standard Heavy Duty Grit Type: Standard ExtremeCore® MOHS Hardness Scale: 7 9 Suitable For: Industrial and Commercial Premises Areas of Heavy Traffic PTV Test Reading Dry: 71 76 PTV Test Reading Wet: 63 70 Traffic Level: Medium Heavy Prices From: £11.40 £16.75 Sheet Thickness: 4-5mm with grit 5-7mm with grit Guarantee: 1 Year 10 Years
- Specifications + Technical Data Sheets
Sizes Length Choice of 800mm, 1200mm, 2400mm Width 1200mm Thickness 4mm FibreGrid offer a free cut-to-size service if the above sizes aren't suitable for you. Call 01440 712722 now to place your bespoke order. Colours Black
- How To Apply
Ensure that the areas to have SlipGrip fitted are clean, dry and free from loose and friable material. Any “dished” or damaged surface areas should be patch repaired to provide a reasonably flat and consistent surface.
Dry fit all SlipGrip panels to ensure they fit freely and that they sit flat down on the surface. If required, SlipGrip can be trimmed on site to suit, ideally using a skill saw with a 4mm diamond blade or an angle grinder with a 1mm blade.
Please ensure that goggles and gloves are worn at all times when any form of cutting is involved.
How to Install
You can install our SlipGrip Standard Flat Sheets easily and quickly with our SlipGrip GRP Flooring Sheet Fixing Kits
Apply an approx. 6mm bead (this may need to be increased dependant on the substrate conditions) of the high strength gap filling adhesive around the periphery of the underside of the SlipGrip panels approx. 25mm in from the edges. Then, starting from the bottom left corner come up at an angle (approx. 200mm across) and then down at an angle, to create a ‘peak and a trough’, repeat this until you reach the end. Immediately press the panel firmly to the substrate to ensure adequate transfer of adhesive (depending on the size of the bead, this will elevate the sheet by approximately 1-1.5mm). A firm bond will be achieved in about one hour under normal circumstances and conditions. Secure with mechanical fixings, as below.
Drill holes 15mm in from all edges at no more than 300mm apart from the centres. Depending on the width of the panels it may be necessary to provide fixing points at 600mm centres down the middle of the panels. As substrates vary considerably, additional fixings may be required to fix the panels down. If fixing down two pieces of flat sheet that is constrained by sides (i.e. a ramp with wall on either side) a 5mm expansion gap should be considered between the two or more sheets. This gap can be filled with a standard high modulus mastic.
1 Fixing Kit covers 1 Full Sheet 2400mm x 1200mm
SlipGrip Standard Flooring Sheets come with a predrilled option which includes predrilled holes in set places for which there is a surplus.
If you require the holes in a certain place please call 01440 712722.
How to Install SlipGrip® Standard Flat Sheets
- Request a Quote/Sample
Shipping Cost Sale Value: UK Next Day: Highlands & Islands: Europe Up to £100 £3.95 Flat Rate 20% of Sale 25% of Sale £100 - £500 5% of Sale 20% of Sale 20% of Sale £500 - £1000 5% of Sale 20% of Sale 15% of Sale £1000 - £3000 5% of Sale 16% of Sale 10% of Sale £3000+ 5% of Sale 10% of Sale 8% of Sale